Accessories

If, once in a while, low numbers of TOX Points need to be joined, this frame can be applied under a suitable press or with a beveling machine.

Available in four executions for the point diameters 3, 4, 5 and 6, 8 mm.

Single Point Frame CEO (195 KB)

The spray equipment has been specially developed to lubricate the sheet metal surface or the TOX-tools just before the joining process. This is good, to reduce the pressing and stripping forces for the TOX-tools. By changing the lubrication condition the formability of the materials is increased.

More information in the data sheet 80.02 TOX-Spray Equipment (152 KB)

Mobile or stationary

Mobile Die Check ZCM: The monitoring system is integrated in the stripper CSRP, which is moved onto the die during the control cycle, then it is pressurized with air. The back pressure in the stripper is measured, and this value is checked in the tongs control, in the TOX-Process Monitoring CEP 400, the TOX ElectricDrive Controller or in the PLC of the assembly line. The controls receive a signal corresponding to the condition of the die.

Stationary Die Check ZCT: The control station is installed within the robot range. The robot brings the TOX-Tongs to the ToolCheck and positions the die at the check station. The die is pressurized with the air, and the back pressure is processed by the evaluation unit or the integrated controls. The resulting signal is given to the installed controls.

more